Attribute	Specification
Form factor	Mnitower
Color	Carbonite/Alloy metallic
System board form factor	ATX (9.6 x 12 in)
Processors	All processors feature Extended Memeory 64 Technology. All Pentium 4 processors feature Hyper-Threading Technology¹. Intel Pentium 4 processor 660 supporting Hyper-Threading Technology (3.6 GHz/ 2 MB, 800 FSB, Single Core)
CPU bus speed	1066 and 800 MHz FSB
Standard L2 Cache	1 or 2 MB L2 cache, depending on specific processor
Chipset	Intel 955X North bridge/ICH7R South bridge
System Memory - one of the following	512 MB DDR-2 PC2-4300 (533 MHz) ECC (2 x 256 MB) 512 MB DDR-2 PC2-5300 (667 MHz) ECC (2 x 256 MB) 1 GB DDR-2 PC2-4300 (533 MHz) ECC (2 x 512 MB) 1 GB DDR-2 PC2-5300 (667 MHz) ECC (2 x 512 MB) 1.5 GB DDR-2 PC2-4300 (533 MHz) ECC (2 x 256 MB + 2 x 512 MB) 2 GB DDR-2 PC2-4300 (533 MHz) ECC (4 x 512 MB) 2 GB DDR-2 PC2-5300 (667 MHz) ECC (2 x 1 GB) 4 GB DDR-2 PC2-5300 (667 MHz) ECC (4 x 1 GB) 256 MB DDR-2 PC2-4300 (533 MHz) non-ECC (1 x 256 MB) 512 MB DDR-2 PC2-4300 (533 MHz) non-ECC (2 x 256 MB) 1 GB DDR-2 PC2-4300 (533 MHz) non-ECC (4 x 256 MB) NOTE: Do not mix ECC and non-ECC memory. The system will not boot if ECC and non-ECC DIMMs are mixed. Only unbuffered DDR2 DIMMs are supported. All DIMMs must be either x8 or x16 width.

Attribute

Specification

Power supply

460 W (continuous) auto-ranging

Operating voltage range

90 – 264 VAC/118 VAC

Rated voltage range

100 – 240 VAC

Rated line frequency

50-60 Hz/400Hz

Operating line frequency range

47 – 66 Hz/393 – 407Hz

Rated input current

7.4A/7.4A

Maximum rated power

460 W

Heat dissipation

Power supply size (wide x high x deep)

97.6 x 150 x 153.71 mm (3.84 x 5.91 x 6.05 in)

Energy start compliant

Yes

FEMP standby power compliant (

Yes if Wake-on-LAN disabled. System board may draw more power if Wake-on-LAN enabled.

Power consmption in ES mode - suspend to RAM (S3) (instantly availabel PC)

~2 W (will depend on configuration)

Surge tolerant full ranging power supply

Withstands power surges up to 2000V

Typical configuration power consumption

One processor (1 x 3.6 GHz 2 MB L2 Cache, Pentium 4 Processor with HT Technology)
One GB memory (2 x 512 MB) Two hard drives (2 x SATA 40 GB)
CD-ROM drive
PCI Express Graphics Card (NVIDIA FX 1400)
One diskette
Monitor

Input pwer consumption	@ 120 Vac/60 Hz
Typical operating mode (system busy)	215 W	= 733.8 but/hr
Windows XP Idle	107 W	= 365.2 but/hr
Standby mode (S3)	2 W	= 6.83 but/hr
Hibernate mode (S4)	~1 W	= 3.41 but/hr^*
Power off (S5)	~2 W ~1 W	= 6.83 but/hr^* = 3.41 but/hr^*
* when Wake-on-LAN disabled

Attribute	Specification
Cooling	Chassis fan 92 mm Processor heatsink fan 70 or 80 mm Power supply fan 92 mm
Temperature	Operating 5^o to 35^o C (40^o to 95^o F) Non-operating -40^o to 60^o C (-40^o to 140^o F)
Humidity	Operating 8% to 85% (non-condensing at ambient) Non-operating 8% to 90% (non-condensing at ambient)
Maximum altitude	Operating 3,000 m (10,000 ft) Non-operating 9,100 m (30,000 ft)

High Definition Integrated Realtek ALC260 Audio
Type	Integrated
High Definition Codec	Yes
FM Synthesis Support	Yes
OPL3 FM Synthesis Support	Yes
Sound Blaster Compatibility	Yes
SPDIF 6-channel pass-through	No
Audio Jacks	One Front fixed stereo analog Microphone-In (20-K ohm Input Impedance); One Front fixed stereo Headphone-Out (expects at least a 32ohm load) One Line-In* (12-K ohm Input Impedance)^* One Line-Out^* (less than 800 ohms Output Impedance, expects at least a 10-K ohm load) One Stereo analog Microphone-In* (20-K ohm Input Impedance) NOTE: *Rear audio port are re-taskable as Line-In, Line-Out, Microphone-In, or Headphone-Out with Optional driver, available only through download from HP support website and not supported by default. External Speakers need to be powered externally.
Sampling	44.1kHz/48 kHz/96kHz/192kHz (output only)
Wavetable syntheses (software)	Yes – GM and FM Midi support, direct music and down loadable soundset (4 Meg DLS level 1 and 2 support)
3D positional sound	No
Digital audio	Yes
<div

HP XW4300 Workstation